Mikrotron MC13xx Bedienerhandbuch PDF herunterladen (Seite 16)

cording, the recorded frames are displayed simultaneously. After recording, the first (oldest) recorded

frame will be displayed.



Recording in non circular mode may only be achieved with

MotionBLITZ®Kit user interface program and not with the trigger signal!

5.5 Recording in circular mode

Circular mode should be used if a trigger is applied. The trigger may be the closing of the camera's trig-

ger switch, a trigger signal or by clicking on the stop button in the

MotionBLITZ®Kit control software. A trigger is necessary if images are needed before and/or after an

event. The trigger defines the point of time of your event.

Circular mode is selected with menu "Record" => "record setting" => "circular..".

There are 2 various methods to start and stop the circular recording as described elsewhere in this manu-

al. In circular recording mode the recorded frames are displayed simultaneously. The number of frames

that will be recorded before the trigger, called “pre-trigger frames”, is determined in menu "Record"

=> "record setting" => "circular.." => "Frames before trigger".

After recording, the frame immediately after the trigger will be displayed, the timestamps will be set in

relation to the point of time of the trigger-moment, i.e. the first frame after the trigger is set to 0 ms.

Negative values indicate that the displayed frame was recorded before the trigger, positive values indic-

ate frames after the trigger, called “post-trigger frames”

5.5.1 Start recording

To start a recording:

Press the start recording button

(Shortcut F5-key) in the MotionBLITZ®Kit control program,

Apply 0-V to the triger input pin-0 at least for 40ms to start recording .

5.5.2 Stop recording

There are 2 methods to stop recording

Apply a triggersignal to the appropriate Inspecta-5 input connector

press the stop (Shortcut F12-key) button in the MotionBLITZ®Kit control program.

MotionBLITZ®Kit Manual Ver.2.0 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 50 51

Keine Kommentare

Mikrotron MC13xx Bedienerhandbuch Seite 16